de'longhi ec155 manual

•This appliance is to be utilised for domestic use only. •The power cable must never be replaced by the user. Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left where children might find it and plug it into a supply socket - with the obvious consequent danger. 23) by unscrewing in the direction indicated by the arrow on the cap. 5.Dip the cappuccino maker into the milk (fig. You might not need every tool for every procedure. Make sure the appliance is not hot and that it is unplugged from the mains; Using a screwdriver, unscrew the screw fixing the espresso boiler outlet (fig. Replace the assembly in the steel filter container (fig. •When the appliance is not in use, turn off and disconnect the plug from the socket. These are some common tools used to work on this device. With one hand, hold the cappuccino tube firmly and with the other unscrew the cappuccino maker itself by rotating clockwise and extracting downwards (fig. 8) and fill it with one level measuring spoon of ground coffee (fig. 7.To remove the used coffee lock the filter with the built-in lever and let the coffee fall out by knocking the over turned filter holder (fig. $197.99. 29), making sure the pin is inserted in the hole in the support (see arrow in fig. Note: to prepare more than one cappuccino, first make all the coffees then at the end prepare the frothed milk for all the cappuccinos. 8.Pour the frothed milk into the cups containing the espresso coffee.Your cappuccino is now ready. View a manual of the DeLonghi EC155 below. Wash the cappuccino maker and steam nozzle thoroughly with warm water. 7). To avoid any splashing, do not detach the filter holder while the machine is dispensing coffee. Note: Use pods which conform to the ESE standard: this will be indicated on the packaging by the symbol as in fig. 21). This is the only way to ensure optimum results and maximum safety. 12). Ideally use a small stainless steel jug. Dip the cappuccino maker into the milk (fig. 7). Do not forget to tighten the mains lead clamp on the plug. 4.Place the container with the milk under the cappuccino maker. Then press the steam button (fig. 7.To eliminate residues of the solution and scale, rinse the tank well, fill with clean water and replace in its housing. Never allow the appliance to be used by children or unfit persons. Do not exceed the MAX level on the water tank. To ensure your espresso coffee is dispensed at the right temperature it is essential that the coffee unit is preheated. There are no questions about the DeLonghi EC155 yet. Steam is given off by the cappuccino maker, giving the milk a creamy frothy appearance.To obtain a creamier froth, dip the cappuccino maker into the milk and rotate the container with slow movements from the bottom upwards. 28. Use the same cup that the coffee will be served in, so that it may be preheated. 4).Wait until the OK indicator light comes on (fig. 18). Attach the filter holder to the machine by positioning the handle to the left of the boiler outlet, then pushing upwards and turning the handle to the right (as in preheating the machine fig. This machine has been built to make coffee and to reheat beverages; please be careful to avoid burns from the sprays of hot water or steam and avoid any improper use. The milk must be at refrigerator temperature (not hot!). It is a 15 BAR pump. •Rinse all components and clean the metal filter thoroughly in hot water using a brush (fig. Use the same cup that the coffee will be served in, so that it may be preheated. Once the required quantity of coffee has been obtained, interrupt delivery by pressing the same button again (fig. •The manufacturer takes no responsibility for damage derived from improper use. It also consists of a removable 35-ounce (1-liter) water tank, dishwasher-safe spill tray, and stainless steel boiler. 15) and wait for the steam indicator light to come on (fig. i n s t r u c t i o n s. Coffee Maker. Remove the crema enhancer cup (fig. All manuals on ManualsCat.com can be viewed completely free of charge. 5.Press the coffee button, half empty the tank and every now and then rotate the steam knob to allow a little of the solution to run off.Then switch off by pressing the button again. Leave the solution to work for about 15 minutes, then run off the rest of the water in the tank. Always follow the instructions on the pod pack to position the pod on the filter correctly. 6). 2.With one hand, hold the cappuccino tube firmly and with the other unscrew the cappuccino maker itself by rotating clockwise and extracting downwards (fig. 3.Position a cup under the filter holder. In choosing the size of the container, bear in mind that the milk increases in volume by 2 or 3 times. 6.Leave the solution to work for about 15 minutes, then run off the rest of the water in the tank. WARNING: it is completely normal for there to be water in the compartment under the tank; as a result, this compartment should be dried using a clean sponge. The lack of respect for this point may compromise the safe use of the appliance. Important: should the coffee holder for pods be used after one for ground coffee, it’s necessary to clear the ground coffee remaining in the boiler outlet.This cleaning operation is necessary in order to avoid water leakages. •Never install the machine in an environment that can reach a temperature less than or equal to 0°C (if the water in it freezes, the coffee maker may be damaged). Replace the tank by connecting the valve at the bottom of the tank with the hole in the base on the machine. 5.Wait until the “OK” light comes on (fig 6) then press the coffee button (fig. 5.Proceed as in points 4, 5 and 6 of the previous section (how to prepare espresso coffee using the filter holder for ground cof-. the holes are not blocked. 2.Press the steam button (fig. In the event of incompatibility between the plug on the appliance and the socket, have the plug replaced by a qualified professional. Make sure the two holes indicated by the arrows in fig. Make sure the holes in the metal filter are not blocked. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. Perhaps the users of ManualsCat.com can help you answer your question. Replace the cappuccino maker by inserting it and rotating anticlockwise. 10). At the end of its working life, the product must not be disposed of as urban waste. Only 4 left in stock - order soon. Press the coffee button and operate the appliance until the tank is completely empty; 8.Press the button again and repeat the last operation. Ensure that the cup or cups line up with the dispensing holes on the filter holder. 14). Make sure to insert the pin on the plastic disk into the hole in the gasket indicated by the arrow in fig. If desired, add sugar and sprinkle a little powdered chocolate or cinnamon on top of the. 10). •Do not allow children to play with the appliance. 22 are not blocked. De'Longhi ECP3420 15 Bar Espresso and Cappuccino Machine with Advanced Cappuccino System, 15" 4.2 out of 5 stars 1,335. For starters, here’s what’s similar about them: You can make single-shot, double-shot, or pre-ground pod espressos with each. 16).The OK indicator light indicates that the boiler has reached the ideal temperature for steam production. Preheat the machine as described in the ‘Preheating the Coffee Machine’ section, attaching the coffee filter holder with 1 cup or pod filter to the unit.This procedure ensures that the coffee is delivered at a hotter temperature and that the seal of the holder is more effective. 2.Place a container under the cappuccino maker. To detach the filter holder, turn the handle from right to left. 14). 3.Insert a pod, centring it as far as possible on the filter (fig. 4). Accessibility. IMPORTANT: for correct operation, before adding the ground coffee to the filter holder, make sure the filter is free from ground coffee from the previous infusion. Press the coffee button, half empty the tank and every now and then rotate the steam knob to allow a little of the solution to run off.Then switch off by pressing the button again. If the cable should become damaged, or needs to be replaced, please contact a Service Centre authorized by the manufacturer.